Do not rebuild

Ability to change like no other

Real World CAD scenarios:

Scenario 1: As we are building in CAD we make mistakes often perhaps a ring size is off, or the stones aren't the right size or it just doesn't look right!!!!

Scenario 2: We have a model made that we added to our Virtual Inventory, a customer comes in likes it but needs many changes.

In the attached Vid we have a Ring Size 6, with a 7X5 Oval Center about 5mm off the finger. It also has 1.25mm side stones around the bezel and the same completely around the ring shank. A customer comes in and likes the basic concept of the ring, but they say it looks a bit bulky, can you change that? By the way, can you also change the the size of the center stone that one is to small, also how about the stones around the bezel and shank, can they be made bigger, and lets make the shank a bit lower? And by the way I need it in a Size 10 with ZERO DISTORTION!!!..

We will make a:

• larger ring size
• Shank Lower and Narrower and able to take larger stones
• Bigger Center Stone
• Change the angle and shape of the bezel and be able to take larger stones
• Change the Bezel Size
• Put bigger stones on the side
• Make the Ring Shank narrower and have more curvature
• Bigger stones in the ring shank
• Smaller wires under the center stone